State-of-the-Art Surface Technology

Resilient by Design

Hello Coating Technology!

Broad Selection of
High-Performance Coatings

We always match the coating system to the job for optimal performance and cost effectiveness. Because of our unique target application, build up and stains are cleaned, pits and scratches are repaired, and discolouration is corrected.

Anticorrosion

Enhanced corrosion protection that repels water, saltwater, and aqueous acids.

Anticontamination

Preventing absorption of water, oil and carbon.

Transformational Coating Systems

We are experienced in all aspects of surface preparation, protective coatings and on-site abrasive blasting. We deliver a complete range of coating systems from basic protective coatings to long-term silicate and polymer coatings.

Our coating technologies are resistant to:

  • Mold and mildew
  • Water
  • Corrosion
  • UV rays
  • Efflorescence
  • Soiling

Surface Protection

The Science Behind our Application

No two surfaces are alike. While the challenges may be the same for many clients, the solutions are not. Each substrate requires a different approach:

Nonporous

  • One application
  • Minor surface penetration
  • Microscopically self levelling
  • Dries to touch in one hour
  • Cures in seven days
  • Chemically and physically resistant
  • Transparent

Porous

  • Coatings absorb to a minimum of 10 mm
  • Coatings fill the gaps molecularly, enveloping particles and bonding chemically
  • Dries in 1–3 hours
  • Cures in 48 hours
  • Practically invisible

Surface Preparation & Best Practices

A revitalization job is only as good as the underlying surface preparation. Without a solid, clean surface for paint and coatings to adhere to, the work will eventually fail. This failure can result in additional corrective costs that often exceed that of doing the job properly in the first place.

Paints and Epoxies

  • Epoxies, paints and chemicals break down an unprotected surface over time. These products hide the problem for a little while, but they are masks, not solutions.
  • Elastomeric and non breathing.

Polymer and Silicate Coatings

  • Maintains desired expected result
  • Will not chip or peel
  • Surface has to be meticulously prepared to avoid bleeding
  • Longer lasting
  • Provides a protection not achieved by paints
  • Microscopic breathability

Invest in a Guaranteed Solution

Restoring Asset Value & Peace of Mind

Asset Maintenance

Many products fail from moisture, water, oil or simply getting too dirty for continued use. Our non stick surface protection coatings improve building image and environmental scores, lower maintenance costs, and require less time, chemicals and effort to clean.

Satisfaction & Warranty

Our client’s complete satisfaction is always our primary goal. Our superior surface protection is guaranteed on an asset-by-asset basis.